ja vemStak napisal/-a:Ojej! Google Chrome ne najde mesta http://www.bleedkit.com.
Koda: Izberi vse
Registrant:
Janez Kralj
Domain Name: BLEEDKIT.COM
Domain servers in listed order:
NS1.PLENUMX.COM
NS2.PLENUMX.COMMimogrede, bleedkit 2.0. je na zalogi.NPT and BSP are two different standards for threaded pipes. NPT stands for National Pipe Tapered and is primarily utilized within the United States. BSP, or British Standard Pipe, can be found in many other countries. The difference between these two thread types can be seen in the number of threads per inch and the angle at which the threads themselves are cut.These sizes and pitches vary depending on the size of the pipe. BSP pipes often includes more threads per inch (TPI) than NPT, but these are not standard rules. A pipe of one inch in diameter, threaded to NPT standards, includes 11.5 TPI, while BSP uses only 11. As the pipe becomes smaller, the TPI increases in both standards from 27 TPI in a pipe of 1/16" NPT pipe, to a TPI of 8 in pipes of 2 1/2" diameter or larger. Though NPT and BSP are common throughout the world, many cities and industries, such as fire fighting, define slightly different thread standards.The two standards are also further divided into whether the pipe threads are tapered or parallel. Parallel threads maintain the same outside diameter throughout, and thus do not form a tighter seal as one goes further down the thread. By contrast, taper threads create an increasingly tight seal as the pipe is screwed in further. Plumbers typically use tapered threads in applications relating to gas, while parallel threads are common with water lines. The British Standard Pipe has two types, BSPT (British Standard Pipe Taper) and BSPP (British Standard Pipe Parallel). These two types have the same angle, pitch and number of threads, but the BSPT will have a tapered thread while BSPP uses a parallel thread. National Pipe threads standards have two types: NPT (National Pipe Taper) and NPP (National Pipe Straight). NPT similarly differs from NPP through the usage of a tapered thread.
če bi vedel koliko teh nastavkov smo že sprobal. Enostavno so ali prekratkri navoji, ali pa je vse skupaj predebelo.Vitto1 napisal/-a:nastavke ki jih rabiš pri bleed kitu ti priporočam da vzameš od proizvajalcev ala Festo, Metal works, SMC, za strojno pnevmatiko M5 za cev fi 4. zakaj? ker so to evropski(SMC japonski) proizvajalci, ki s standardi navojev za razliko od kitajcev nimajo težav. Edini meni znan distributer je firma Lipro z Kopra, mislim da so tudi uvozniki...
Pa ne bi bilo slabo ponuditi 100 ml za recimo 3-4 eur. Ker Dot ne moreš imeti dolgo odprtega doma na zalogi.Thema napisal/-a:Pri ceni ~10e za .5 litra motula a je sploh smiselno delat 120ml embalazo?
¨Thema napisal/-a:A je kak fix za puscanje med cevko in medeninastim delom pri v3?
